Isopropyl Alcohol Wipre Before Ceramic Coat

Ipa or isopropyl alcohol wipe.

Isopropyl alcohol wipre before ceramic coat.

You ll need several microfiber towels to dry polish and wipe off the ipa. Wipe down with ipa solution diluted isopropyl alcohol this final wipe down is necessary to remove any waxes or oils that may remain on the surface so that the ceramic coating will adhere properly. And perfecting the paint before im ready to apply ceramic coat. This will remove all the residue of the clay bar treatment any excess polish or wax so the surface is perfectly clean.

Isopropyl alcohol works to break down these oils and other surface contaminants and leaves a completely clean area to apply the ceramic coating. November 1 2019 at 6 31 pm. Purchase a spray bottle and distilled water to use with the alcohol. Isopropyl alcohol or ipa solution can remove all the remaining contaminants present on the paint.

Be sure to use this before applying ceramic coatings or waxes. In general thousands of people use isopropyl alcohol in some way or another although there are some that prefer not to ever use it on paint. After polishing each panel i was sure to wipe off the excess polishing compound off with a clean microfiber. If concerned about your current clear coat levels check out this video on youtube for tips on measuring it.

The last step before the ceramic coating process is a thorough wipe with an ipa isopropyl alcohol based solution to remove any existing residues or surface contaminants left behind during the polishing process. Polishes and cutting compounds contain carrier oils that allow the material to grasp onto the surface. Pearl nano decon ceramic coating prep spray is the perfect coating prep cleaner for removing polish oil residue grease and old waxes from all surfaces. However when i go to do the ipa wipedown with 70 ipa i keep on getting excessive white powdery residue after the alcohol dries.

Polishing and paint correction deal with swirls fine scratches and paint imperfections prior to applying the ceramic coating. Always use fresh and clean microfiber towels with each step to avoid. Pearl nano decon ceramic coating prep spray is a combination of mild solvents that dissolves and removes all wax and oil. If this step isn t executed properly all the hard work and efforts you ve previously performed can all go to waste.

The last step before the ceramic coating process is a thorough wipe with an ipa iso propyl alcohol based solution to remove any existing residues or surface contaminants left behind during the polishing process. But without coating the vehicle it ll easily get ruined again. Isopropyl alcohol ipa panel wipe. The last item to complete is the ipa spray.

So make sure you don t keep your vehicle waiting for too long after finishing the pre coating tasks. A diluted isopropyl alcohol solution has been shown to be the best option in this case. It makes your car look like a new vehicle.